iNSTALLATiON
AND SERVICE
MUST
BE
PERFORMED
BY A QUALIFIED
iNSTALLER.
iMPORTANT:
SAVE
FOR LOCAL
ELECTRICAL
iNSPECTOR'S
USE.
READ
AND SAVE THESE
iNSTRUCTiONS
FOR
FUTURE
REFERENCE.
• ALL RANGES
CAN TiP
• INJURYTO
PERSONS
COULD
RESULT
• iNSTALL
ANTi=TIP
DEVICE
PACKED
WiTH
RANGE
• SEE iNSTALLATiON
iNSTRUCTiONS
I_
if the
information
in this I
manual
is not followed
exactly, a fire or I
explosion
may result causing
property I
damage,
personal
injury or death,
j
FOR YOUR SAFETY:
m
Do not store or use gasoline
or other
flammable
vapors and liquids in the
vicinity of this or any other appliance.
=
WHAT TO DO iF YOU SMELL GAS:
• Do not try to light any appliance.
• Do not touch
any electrical
switch;
do
not
use
any
phone
in your
building.
• Immediately
call your gas supplier
from
a neighbor's
phone.
Follow
the gas supplier's
instructions.
• if you
cannot
reach
your
gas
supplier, call the fire department.
=
Installation
and
service
must
be
performed
by a qualified
installer,
service agency
or the gas supplier.
Clearances
and Dimensions
Location: Check location where the range will be
installed. Check for proper electrical and gas supply,
and the stability of the floor.
Dimensions that are shown must be used. Given
dimensions
provide minimum
clearance.
Contact
surface must be solid and level.
Refer to your serial plate for applicable
agency certifications
Provide Proper Fuel Type
Provide proper fuel type
Before proceeding:
You r range is factory preset to operate on
natural gas. If LP. conversion is needed, contact your local LP.
Gas provider for assistance.
The LP. conversion kit may be located on the lower rear back
panel of the range. If no LP. kit is provided,
contact your
product dealer to obtain the correct LP. conversion kit.
important
Note to the Consumer
= Keep these instructions with your Use & Care Guide for
future reference.
• As when using any appliance generating heat, there are
certain safety precautions you should follow. These are
listed in the Use & Care Guide, read it carefully.
Be sure your range is installed and grounded properly by a
qualified installer or service technician.
Make sure the wall coverings around the range can
withstand the heat generated by the range.
To eliminate the need to reach over the surface elements or
burners, cabinet storage space directly above the range
should be avoided.
important
Notes
to the
installer
= Read all instructions contained in these installation
instructions before installing range.
Remove all packing material from the oven compartments
before connecting
the gas and electrical supply to the
range.
Observe all governing codes and ordinances.
Be sure to leave these instructions with the consumer.
t
48-1/2"
maximum
36+1/8"
door
closed
maximum
door
29-7/8"-.
p/n 316454923 (1006)