A2DP Stereo Music Only DISPOSAL HFP for Phone Call Only CERTIFICATION AND SAFETY APPROVALS PAIRING WITH OTHER SMH5 HEADSETS FOR INTERCOM CONVERSATION PAIRING WITH OTHER SENA HEADSET MODELS FOR INTERCOM CONVERSATION FCC Compliance Statement USING THE SMH5 FCC RF Exposure Statement...
Page 3
SMH5 FCC Caution CE Declaration of Conformity Industry Canada Statement Bluetooth License WAIVER AND GENERAL RELEASE Two Year Limited Warranty Limitation of Liability Return for Full Refund WARNING...
Thank you for choosing the SENA SMH5, Bluetooth Stereo Headset and Bluetooth intercom up to 400 meters (430 yards)* Intercom for scooters and motorcycles. With the SMH5, you can call handsfree Multi-pair Bluetooth intercom to pair with 3 other headsets...
SMH5 INSTALLING THE SMH5 ON YOUR HELMET 1. Loosen the two screws on the back plate of the clamp using the enclosed Allen Wrench. Insert the back plate of the clamp unit between the internal padding and external shell of the helmet, and tighten the two screws.
Page 7
Note: until you feel the click that signals a secure attachment. Sena recommends the clamp unit over the glued surface mounting plate. Even though the glued surface mounting plate is provided for convenience, Sena does not assume any responsibility for use of it.
Page 8
SMH5 close to your mouth when you wear the helmet. You can use the enclosed velcro pad 7. To remove the headset main unit from the clamp, please make sure to pull out the and holder for the boom microphone to ensure secure placement.
SMH5 with the SMH5 if the charger is approved by either FCC, CE, IC or other locally POWERING ON/OFF AND CHARGING approved agencies that Sena accepts.* - The USB Power Cable is also used for firmware upgrade of the SMH5.
Low, 0~30% 1. Turn on the SMH5 and press the Phone Button for 5 seconds until the LED When you power on the headset, keep pressing the Jog Dial and Phone flashes red and blue alternately and you hear multiple beeps. You will hear a Button simultaneously for about 3 seconds until you hear three high tone voice prompt saying “Phone pairing”.
GPS which uses mobile phone profile, you have to pair the SMH5 with the GPS, and the GPS with the mobile phone. Most 1. If the Bluetooth stereo device is integrated with the mobile phone such as motorcycle specific GPSs use mobile phone profile.
4. Enter 0000 for the PIN. Some smartphones may not ask for PIN. may need to selectively use the SMH5 for A2DP stereo music only or for mobile phone handsfree only. This instruction is for advanced users who want to pair the SMH5 to their smartphones only with one selective profile: A2DP for stereo 1.
INTERCOM CONVERSATION The SMH5 can be paired with up to three other headsets for Bluetooth Intercom conversation. 1. Turn on the two SMH5 headsets (A and B) that you would like to pair with Pairing A & B each other.
The previous Intercom friend becomes second intercom friend, and third intercom friend. The SMH5 can be paired with all other SENA headset models such as the Note: SMH10 and the SPH10 for intercom conversation. Please follow the same For example, after the pairing procedures listed above, headset D is the first intercom friend of procedure as above to pair with these headset models.
SMH5 4. To reject a call, press the Jog Dial for 2 seconds until you hear a beep while USING THE SMH5 the phone is ringing. 5. To transfer a call between the mobile phone and the headset during the phone conversation, press the Phone Button for 2 seconds until you hear a beep.
SMH5 incoming call, you can answer the phone by saying “Hello” or any other word loudly. This is enabled from the factory but you can disable this. If this mode is disabled, the only way to answer an incoming call is to tap the Phone Button.
Dial for 2 seconds until you hear a beep. In this case, the SMH5 automatically tries to reconnect the intercom every Unlike other motorcycle Bluetooth headsets, this prevents a user from being 8 seconds.
You can listen to stereo music by Bluetooth wireless stereo. The Bluetooth audio device must be paired with the SMH5 by following the Bluetooth Stereo Device Pairing procedures described in the previous chapter. The SMH5 supports the Audio/Video Remote Control Profile(AVRCP), so if your Bluetooth...
LED flashes for 2 seconds. If any button is not pressed within 10 seconds, it remains unchanged and goes back to stand-by. 1. To restore the SMH5 to factory default settings, press and hold the Phone Button for 12 seconds until the LED shows solid red and you hear high tone double beeps.
When the SMH5 is not working properly or is in faulty status for any reason, you may reset by pushing the pin-hole reset button at the back of the headset main unit.
The battery can be charged and discharged hundreds of times, but Mobile phone voice command Tapping — — it will eventually wear out. Recharge the battery only with SENA approved Call transfer while on the phone 2 sec — High tone beep chargers designated for this device.
SMH5 MAINTENANCE AND CARE DISPOSAL The Product should be treated with care and the following suggestions will The crossed-out wheel bin symbol on the product, help you protect your warranty coverage. |literature, or packaging reminds you that all electrical and electronic products, batteries, and accumulators must be 1.
This product is CE marked according to the provisions of the R&TTE Directive harmful interference to radio or television reception, which can be determined by (99/5/EC). Hereby, SENA declares that this product is in compliance with the turning the equipment off and on, the user is encouraged to try to correct the...
The Bluetooth® word mark and logos are owned by the Bluetooth SIG, Inc. and any use of such marks by SENA is under license. Other trademarks and trade names are those of their respective owners...
SENA hereby notifies you that using this Device may also be in contravention to weather and road conditions if you choose to use the product headset, including local, federal, state or national laws or regulations, and that any use of the Device all derivative models irrespective of its commercial name or branding (the “Device”),...
This warranty is limited to the repair and/or replacement, at SENA’s discretion, that could cause serious disability; (b) these risks and dangers may be caused...
Customer agrees to insure the Product or assume the PAID FOR THE PRODUCT. risk of loss or damage in transit, to prepay shipping charges to SENA, and to use the original shipping container or equivalent. IF YOU ARE UNWILLING TO ACCEPT AND AGREE TO THE ABOVE...
SMH5 WARNING SENA informs that using this device in public traffic may not be authorized by the law. Please check your local law and use this device only out of public traffic such as private properties or closed circuits. If the simultaneous use of both ear speakers while riding a motorcycle is prohibited by your local law, please use only a single ear speaker while riding.
Page 29
1.0.0 www.senabluetooth.com User's Guide for Firmware V1.0...
Need help?
Do you have a question about the SMH5 and is the answer not in the manual?
Questions and answers