Memory Module - HP EliteBook 1040 G1 Maintenance And Service Manual

Memory module

NOTE: Primary and expansion memory is installed in a stacked configuration in the bottom of
the computer.
NOTE: DDR3 memory is not supported. Only DDR3L memory is supported.
Description
4-GB memory module (DDR3L, 12800, 1600-MHz)
Update BIOS before adding memory modules
Before adding new memory, make sure you update the computer to the latest BIOS.
CAUTION:
various system problems.
To update BIOS:
1. Navigate to www.hp.com.
2. Click Support & Drivers > Drivers & Software.
3. In the Enter a product name/number box, type the computer model information, and then click Search.
4. Click the link for the computer model.
5. Select the operating system, and then click Next.
6. Under Step 2: Select a Download, click the BIOS link.
7. Click the link for the most recent BIOS.
8. Click the Download button, and then follow the on-screen instructions.
Before removing a memory module, follow these steps:
1. Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2. Disconnect the power from the computer by unplugging the power cord from the computer.
3. Disconnect all external devices from the computer.
4. Remove the bottom cover (see
5. Disconnect the battery (see
Remove the memory module:
1. Spread the retaining tabs (1) on each side of the memory module slot to release the memory module.
(The edge of the module opposite the slot rises away from the computer.)
44 Chapter 5 Removal and replacement procedures for Authorized Service Provider parts
Failure to update the computer to the latest BIOS prior to installing new memory may result in
Bottom cover on page
Battery on page
35).
41).
Spare part number
747221-005