Rack and Stack
The PowerEdge M1000e has been qualified for Rack and Stack support along with specified blade
servers. Details are as follows:
Qualifications are limited to Dell branded racks shipped by an air-ride van.
The M1000e is qualified to ship fully populated with full height blades up to M910 blade weight
or up to pallet weight limits.
The heaviest blade qualified to date is the M910.
—
Any future blade that is heavier than the M910 or incorporates significant changes in
—
mechanical layout may require qualification testing.
The M1000e is qualified to ship partial configurations of blades up to pallet weight limits.
The M1000e is qualified to ship without blades.
The M1000e is qualified to ship on VersaRail only.
The following screws should be secured with permanent Locktite™ and seated to the following
torques:
VersaRail screws
—
Chassis thumbscrews
—
Screws that secure the shipping clip
—
Screws that secure the strain relief bar
—
I/O modules should have their latches secured mechanically.
Power supply blanks should be shipped uninstalled.
The M1000e PDUs are qualified for zero-U tool-less mounting.
PowerEdge M1000e Technical Guide
57
20 in-lb
20 in-lb
20 in-lb
20 in-lb