Yamaha FJR1300AS 2011 Owner's Manual page 27

When the average fuel consumption
mode is selected, the display flashes
for five seconds, and then, depending
on the unit set, "AV_ _._ km/L" (aver-
age distance that can be traveled using
1.0 L of fuel) or "AV_ _._ L/100 km" (av-
erage amount of fuel necessary to trav-
el 100 km) is displayed.
To reset the average fuel consumption
display, push the reset button to select
the mode again, and then push the re-
set button for 1 second while the dis-
play is flashing.
TIP
G
To switch between the two aver-
age fuel consumption displays,
push the reset button for 1 second
when either display is shown.
G
After resetting an average fuel
consumption display, "_ _._" will
be shown for that display until the
vehicle has traveled 1 km.
NOTICE
If there is a malfunction, "– –.–" will
be displayed. Have a Yamaha dealer
check the vehicle.
INSTRUMENT AND CONTROL FUNCTIONS
Ambient temperature,
neous fuel consumption and aver-
age fuel consumption modes (for
the UK only)
1. Ambient temperature/instantaneous fuel
consumption/average fuel consumption
2. Select button
3. Reset button
Push the reset button to switch the dis-
play between the ambient temperature
mode "Air", the instantaneous fuel con-
sumption mode "MPG" and the aver-
age fuel consumption mode "AV_ _._
MPG" in the following order:
ECA15472
Air → MPG → AV_ _._ MPG → Air
instanta- Ambient temperature mode
1. Ambient temperature
This display shows the ambient tem-
perature from –9 °C to 50 °C in 1 °C in-
crements. The temperature displayed
may vary from the ambient tempera-
ture.
TIP
G
G
G
3-12
If the ambient temperature falls be-
low –9 °C, a lower temperature
than –9 °C will not be displayed.
If the ambient temperature climbs
above 50 °C, a higher temperature
than 50 °C will not be displayed.
The accuracy of the temperature
reading may be affected when
riding slowly [approximately under
3