Configuration Menu - Hayward EcoStar SP3400VSP Owner's Manual

5.6. Configuration Menu

Configuration Menu
1.
2.
Configuration Menu
press > to enter
3.
Use + / - to adjust,
> go to next item
4.
Time:
+ change
5.
Set Day and Time
Thursday
6.
Speed Selection
7.
MAX allowed speed
3450 (600-3450rpm)
8.
MIN allowed speed
600 (600-3450rpm)
Note: For SP3400VSPVR. Minimum allowed speed cannot be set lower than 1000 rpm.
Set max-speed Prime
9.
Period: Auto Sense
Note: User may set the pump to automatically sense when it has reached full prime. User may also set the pump to
prime at the maximum allowed speed for 3 minutes. The 3-minute prime mode should be used if the maximum
allowed speed is set below 3000 rpm.
Remote Control Mode
10.
Standalone/Hayward
(Details in section 3.10)
Set COMM Bus Address
11.
Pool Filter (1)
Note: The pump can be controlled by a Hayward control through the COMM Bus, or by a third party control using
relay contacts to select speeds set in the Timer Menu. If the COMM Bus is selected, then a bus address must be
Page 18 of 32
Screen
Locked
Th 1:27PM
or > skip
1:27p
rpm
USE ONLY HAYWARD GENUINE REPLACEMENT PARTS
EcoStar Variable Speed Pump
Buttons
Used Comments
<> Press & hold < and > buttons for several seconds to
unlock Configuration Menu
<> Use > to enter Configuration Menu
+- Use + to change clock setting
<> Use > if clock is correct
+- Adjust day/time setting
<> Move to next selection, then to next menu item
+- Select whether to display speed in rpm (Revolutions
per Minute) or % of full speed
<> Move to next menu item
+- Set maximum running speed of pump
<> Move to next menu item
+- Set minimum running speed of pump
<> Move to next menu item
+- Select pump prime mode
<> Move to next menu item
+- Select Standalone/Hayward or Relay Control
<> Move to next menu item
+- Select COMM Bus Address for pump
<> Move to next menu item
IS3400VSP Rev-B