CONTENTS MAKING CAPPUCCINOS AND MILK BASED COFFEES...13 Filling and attaching the milk container ......13 INTRODUCTION ............7 Adjusting the amount of froth ........13 Symbols used in these instructions ........7 Making cappuccino or macchiato ........13 Letters in brackets ............7 Making frothed milk (without coffee) ......13 Troubleshooting and repairs ..........7 Preparing milk (unfrothed and without coffee) ...13 Cleaning the milk frother using the CLEAN function ..14...
INTRODUCTION • Unplug directly from the plug only. Never pull the power cable as you could damage it. Thank you for choosing this automatic espresso and cappuccino • To disconnect the appliance completely, place the main machine. We hope you enjoy using your new appliance. switch at the back of the appliance in the 0 position (fig. Take a few minutes to read this Instruction for Use.
Description of the accessories Keep this Instruction for Use. If the appliance is passed to other persons, they must also be (page 2 - C ) C1. Pre-ground coffee measure provided with this Instruction for Use. C2. Cleaning brush DESCRIPTION C3. Hot water spout C4.
Setting up the appliance Each time the appliance is turned on, it performs an automatic preheat and rinse cycle which cannot be interrupted. Please note: The appliance is ready for use only after completion of this • Coffee has been used to factory test the appliance and it cycle. is therefore completely normal for there to be traces of Danger of burns! coffee in the mill.
Replacing the filter 4. Turn the selection dial (fig. 8) until the required operating For instructions on how to replace the filter, see the section time (15 or 30 minutes, or 1, 2 or 3 hours) is displayed; “Replacing the filter” (page 18). 5.
Enable/disable the beep 1. Press the P button to enter the menu; This enables or disables the beep emitted by the machine 2. Turn the selection dial (fig. 8) until “Default values” is each time the buttons are pressed or an accessory is inserted/ displayed;...
Making coffee using coffee beans ≃90 LONG ≃120 Important! EXTRA LONG COFFEE Do not use caramelised or candied coffee beans as they could Customising the “my coffee” quantity stick to the coffee mill and make it unusable. The appliance is set by default to automatically deliver 30 ml of 1.
Adjusting the amount of froth 1. Press the button (fig. 7) repeatedly until “Pre- Turn the froth adjustment dial to adjust the amount of froth ground” is displayed. on the milk delivered while making cappuccino and milk based 2. Make sure the funnel is not blocked, then add one level coffees.
HOT WATER Cleaning the milk frother using the CLEAN function Important! Danger of burns Important! Danger of burns. When cleaning the internal tubes of the milk container, a little Never leave the machine unsupervised while delivering hot hot water and steam leak out of the frothed milk spout. water.
The appliance cannot be used to make coffee until you have dirty. If necessary, remove coffee deposits with the brush cleaned the grounds container. supplied and a sponge. Even if not full, the empty grounds container message is 2. Remove the residues with a vacuum cleaner (fig. 26). displayed 72 hours after the first coffee has been prepared.
5. Rinse inside froth adjustment dial seat with running water (see figure) 6. Check that the intake tube and spout are not clogged with milk residues. 7. Replace dial Please note: correspondence to the word If the infuser is difficult to insert, before insertion, squeeze the “INSERT”), spout and milk two levers shown in the figure to make it smaller.
8. Place an empty container with a minimum capacity of 1.5 soft water ● litres under the hot water spout (fig. 4). slightly hard water ●● Important! Danger di scottature Hot water containing acid flows out of the hot water spout. Avoid contact with splashes of water.
Removing the filter 7. Close the tank with the lid, then put the tank If you want to use the appliance without the filter, you must back in the machine. remove it and notify the appliance of its removal. When you install the filter, Proceed as follows: you must notify the appliance 1.
DISPLAYED MESSAGES DISPLAYED MESSAGE POSSIBLE CAUSE SOLUTION FILL TANK Insufficient water in the tank. Fill the tank with water and/or insert it correctly, pushing it as far as it will go until it clicks into place (fig. 3). EMPTY GROUNDS CONTAINER The grounds container (A14) is full. Empty the grounds container and drip tray, clean and replace (fig.
INSERT TANK The tank is not correctly in place. Insert the tank correctly and press as far as it will go. GENERAL ALARM The inside of the appliance is very dirty. Clean the inside of the appliance thoroughly, as described in the section “Cleaning and maintenance”.
Page 22
The coffee is delivered too The coffee is ground too finely. Turn the grinding adjustment dial one click slowly or a drop at a time. clockwise towards “7” while the coffee mill is in operation (fig. 10). Continue one click at a time until coffee delivery is satisfactory.
Need help?
Do you have a question about the ECAM23.460 and is the answer not in the manual?
Questions and answers