Installing And Connecting The Iv-S30C4 Micro, High-Speed Monochrome Cameras - Sharp IV-C35M User Manual

Connection and Installation Methods
[2] Installing and connecting the IV-S30C4 micro, high-speed monochrome
cameras
(1) Connections
Up to two IV-S30C4 micro, high-speed cameras can be connected to the following controllers using
camera cables.
5
Camera 1
Camera 2
1) Connect the IV-S30KC3/S30KC5 camera cable(s) to the CAMERA 1 and CAMERA 2 connectors
on the controller.
- To connect them, match the keyed portion of the connectors and press in. When they are firmly
connected, you will hear a click.
- To unplug a connector, hold the plug housing and pull it straight out.
- Any camera plugged into the CAMERA 1 connector will be system camera 1 and any camera
plugged into the CAMERA 2 connector will be system camera 2 in the IV-C35M system.
Note 1: Make sure to turn OFF the power before connecting or disconnecting the cameras.
Note 2: If there is only one camera, make sure to connect it as system camera 1.
Remarks
- You cannot use different types of cameras at the same time with the same controller (color
and high-speed monochrome camera can not be mixed). When an IV-S30C4 is connected
to the controller, the other cameras that can be connected to the controller are as follows:
monochrome camera
Camera 2 connector: CAMERA 2
Camera 1 connector: CAMERA 1
3)
Camera
IV-S30C4
cable
Camera
Micro, high-speed
IV-S30C3 (high-speed monochrome camera)
(IV-S30C4)
2)
Connector
Compatible second cameras
5-20
IV-C35M
(side)
1)
Plug