Panasonic KX-TDA100 Installation Manual page 257

Note
1.
During a long programming session, it is highly recommended that you periodically save the system
data to the SD Memory Card. If the PBX undergoes a sudden power failure or if the system is reset for
some reason, all the system data in RAM will be lost. However, if system data has been saved to the
SD Memory Card, it can be easily restored.
To save the system data to the SD Memory Card, (1) click the "SD Memory Backup" icon before
resetting the PBX or turning off the power, or (2) exit the Maintenance Console so that the PBX
automatically saves the system data.
2.
The PC will not perform any shutdown operation, or enter the power-saving system standby mode
while the Maintenance Console is connected to the PBX. To perform either of the operations above,
first close the connection to the PBX.
3.3.1 Installing and Starting the Maintenance Console
6. a.
Select KX-TDA100/200 from PBX Model.
b.
Select the USB tab.
c.
Enter the system password for installer (default: 1234).
d.
Click Connect.
Note
To connect to the PBX via USB, the KX-TDA USB driver
must be installed on the PC, as explained above
in "Installing the Maintenance Console".
7. When country/area data do not match:
a.
Click OK to replace the country/area data of the PBX.
Replacement may take several minutes to complete.
b.
Follow the procedure described in "2.14.1 Starting the
PBX" and restart the PBX.
c.
Repeat step 5 to reconnect the Maintenance Console
to the PBX.
8. Follow the instructions of the Quick Setup wizard and assign
the basic items (Quick Setup).
The system menu appears. You may now begin
programming the PBX.
Installation Manual 257