The Backup Battery; The Main Batteries - Philips VELO500 User Manual

Philips Velo™ 500 User's Manual

The backup battery

The backup battery was installed at the factory, but must be
activated before it will protect your data.
To activate the backup battery
Carefully pull the plastic tab free from the main battery
compartment, and discard it.
To replace the backup battery
1 Remove the screw from the backup battery door, and
then remove the door.
2 Remove the old backup battery.
3 Insert a CR2032 (or equivalent) lithium coin cell backup
battery. The side marked with a + (plus sign) faces up.
4 Replace the backup battery door and the screw.

The main batteries

You can use the Philips Velo Rechargeable NiMH Battery Pack
included with your Velo 500. Rechargeable AA NiCd batteries are
not recommended.
Note Battery life will vary depending on how you use your Velo 500.
To install the main batteries
1 Slide the battery door lock switch down to release the
battery door.
2 Swing the battery door open until it detaches completely.
3 Insert the Philips Velo Rechargeable Battery Pack into the
battery compartment.
A tab on the Philips Velo Rechargeable Battery Pack
indicates the date of manufacture. When you insert the
battery pack, position this tab so you can use it to pull
the battery from the compartment.
4 Replace the battery door, and slide the lock switch up to
lock the battery door.
Caution If you remove all main and backup batteries and
disconnect external power, you will lose all information in your Velo
500 and will need to restore your data from your desktop computer.
12