Canadian Ic Cs-03 Requirements; Ringer Equivalence - Philips VELO500 User Manual

Philips Velo™ 500 User's Manual

Canadian IC CS-03 requirements

Notice: The Industry Canada label identifies certified equipment.
This certification means that the equipment meets certain telecom-
munications network protective, operational and safety require-
ments as prescribed in the appropriate Terminal Equipment
Technical Requirements document(s).
The Department does not guarantee the equipment will operate to
the user's satisfaction.
Before installing this equipment, users should ensure that it is
permissible to be connected to the facilities of the local telecom-
munications company The equipment must also be installed using
an acceptable method of connection. The customer should be
aware that compliance with the above conditions may not prevent
degradation of service in some situations.
Repairs to certified equipment should be coordinated by a repre-
sentative designated by the supplier. Any repairs or alterations
made by the user to this equipment, or equipment malfunctions,
may give the telecommunications company cause
to request the user to disconnect the equipment.
Users should ensure for their own protection that the electrical
ground connections of the power utility, telephone lines and
internal metallic water pipe system, if present, are connected
together. This precaution may be particularly important in rural
areas.
Caution Users should not attempt to make such connections
themselves, but should contact the appropriate electric
inspection authority, or electrician, as appropriate.

Ringer equivalence

Ringer equiv Ringer equiv alence alence alence
Ringer equiv Ringer equiv alence
The Ringer Equivalence Number (REN) of this device is 0.6B.
Notice: The Ringer Equivalence Number (REN) assigned to each ter-
minal device provides an indication of the maximum number of termi-
nals allowed to be connected to a telephone interface. The termina-
tion on an interface may consist of any combination of devices subject
only to the requirement that the sum of the Ringer Equivalence Num-
bers of all the devices does not exceed 5. The equipment uses a CA11A
jack.
50