Table of Contents
Advertisement
D400 Substation Gateway
Chapter 1: Before You Start
Safety precautions
D400 SUBSTATION GATEWAY USER'S MANUAL
Before You Start
Before you begin installing and using the D400, review the information in this chapter,
including the following topics:
•
Safety precautions
•
Regulatory compliance information
•
Product overview
•
Product specifications
•
Storage recommendations
Read and thoroughly understand this guide before installing and operating the unit. Save
these instructions for later use and reference.
Failure to observe the instructions in this manual may result in serious injury or death.
Follow all safety precautions and instructions in this manual.
Only qualified personnel should work on the D400. Maintenance personnel should be
familiar with the technology and the hazards associated with electrical equipment.
•
Never work alone.
•
Before performing visual inspections, tests, or maintenance on this equipment, isolate
or disconnect all hazardous live circuits and sources of electric power. Assume that all
circuits are live until they have been completely de-energized, tested, and tagged. Pay
particular attention to the design of the power system. Consider all sources of power,
including the possibility of back feed.
•
Turn off all power supplying the equipment in which the D400 is to be installed before
installing and wiring the D400.
•
Operate only from the power source specified on the installed power supply module.
•
Beware of potential hazards and wear personal protective equipment.
•
The successful operation of this equipment depends upon proper handling,
installation, and operation. Neglecting fundamental installation requirements may
lead to personal injury as well as damage to electrical equipment or other property.
GENERAL
13
Advertisement
Table of Contents
