CHAPTER 8: SERVICING THE D400
Dual ethernet upgrade kit with card 580-3410
Valid combinations
Installing the 580-3410 dual ethernet card
D400 SUBSTATION GATEWAY USER'S MANUAL
The D400 Dual Ethernet Upgrade Kit (GE part number D400-DE-UPGRADE) allows you to
upgrade your existing D400 device to support dual Ethernet network connections. This
upgrade kit contains the following components:
•
PC/104-Plus 10/100BaseT Ethernet Module card (GE part number 580-2717)
•
Ethernet card to main board cable assembly (GE part number 975-0122)
•
Phillips screws (4 pieces)
•
Hexagonal standoffs (4 pieces)
•
Hexagonal nuts (4 pieces)
This upgrade can be performed using the following components:
D400 Main Board
GE part no. 520-0204 [650 MHz]
GE part no. 520-0205LF [1.0 GHz]
Perform this procedure on an ESD-safe surface to prevent damage to the D400 device and
its components.
The 580-3410 dual ethernet card only works in conjunction with the 1 GHz CPU.
To install the Dual Ethernet Upgrade Kit:
1.
Power down your D400 device.
2.
Remove the D400 main module from the chassis. See "Removing the D400 main
module" on page 99.
3.
Locate the four mounting holes in the D400 main module PCB board noted below.
Attach the hexagonal standoffs to the top of the main board and secure the standoffs
using the four provided hexagonal nuts.
Figure 58: Dual Ethernet upgrade kit - four mounting holes
DUAL ETHERNET UPGRADE KIT WITH CARD 580-3410
Ethernet Module Card
GE part no. 580-2717
Compatible with versions of
D400-S firmware 1.4G and
above
GENERAL
Network Cards
GE part no. 520-0218LF [NET1 slot]
GE part no. 520-0213LF [NET2 slot]
GE part no. 520-0214LF [NET2 slot]
GE part no. 520-0215LF [NET2 slot]
105