Table of Contents
Advertisement
1-2
1. Installing the Copier
Installation Site
To ensure utmost safety and prevent possible malfunctions of the copier, install it in a location which
meets the following requirements.
A place away from a curtain or the like that may catch fire and burn easily.
An area where there is no possibility of being splashed with water or other types of liquid.
An area free from direct sunlight.
A place out of the direct air stream of an air conditioner, heater, or ventilator.
A well-ventilated place.
A dry place.
A dust-free location.
An area not subject to undue vibration.
A stable and level location.
A place where ammonia or other organic gas is not generated.
A place which does not put the operator in the direct stream of exhaust from the copier.
A place which is not near any kind of heating device.
Power Source
The power source voltage requirements are as follows :
220-240 VAC, 5.5A, 50-60 Hz.
Use a power source with little voltage fluctuation.
Voltage Fluctuation
Frequency Fluctuation : Within ± 0.3%
Always use the power cord provided with your printer. When an extension power cord is required,
always use a properly rated cord. If the power cord is not provided, use the following type of power cord:
3 wires, 3x1.00 mm
Rated 300V/10A (with grounding plug)
Space Requirements
To ensure easy copier operation, supply replacements, and service maintenance, adhere to the
recommended space requirements detailed below. Allow a clearance of 150mm or more at the back of the
copier as there is a ventilation duct.
240
<With AFR-14, FN-100, PF-108, PF-110 and AD-10 mounted>
: Within ± 10%
2
Harmonized (<HAR>)
1628.5
1249.5
139
656
593.5
827.5
1027
320
677.5
29.5
558
Unit: mm
1166O253CC
Advertisement
Table of Contents
