Section 3: External Gps Antenna; Antenna Installation - Samsung SCS-2U01 User Manual

Section 3: External GPS Antenna

If the Verizon Wireless Network Extender for Business cannot receive a Global Positioning System (GPS) signal, it may be necessary to improve the reception by installing and then positioning the external
GPS antenna. This section outlines the installation and relocation of this GPS antenna.

Antenna Installation

In some cases, because of its current location, the Network Extender for Business's GPS antenna may not receive an active GPS signal. If a stable GPS signal is not detected, as indicated by the red GPS
LED, install the GPS antenna cable as explained in this section.
Important!: Without a valid GPS signal, the Network Extender for Business cannot function properly.
When positioning the GPS antenna, ensure that it is:
Installed in a horizontal position.
•
Adjacent to a window and in an open area. This ensures clear reception of the GPS signal.
•
Note: GPS signal strength is greatly reduced when passing through walls or other hard surfaces.
To connect the GPS antenna to the Network Extender for Business, follow these steps:
Turn off the Network Extender for Business.
1.
Rotate the wireless antenna down to provide access to the GPS antenna's protective cover.
2.
Note: The GPS antenna receives signals from Global Positioning System to support 911 location.
Slide the protective cover back to expose the rectangular GPS antenna.
3.
4. Slide out the GPS antenna away from the Network Extender for Business.
5. Remove the GPS antenna from its compartment.
Connect and secure the GPS antenna to the end of the provided GPS cable labeled "Connect to GPS Antenna."
6.
Connect and secure the terminal end of the same mini-coax cable to the port on the Network Extender for Business (within the GPS antenna compartment).
7.
Note: For Wall and Ceiling Mount Installation, refer to the Installation Guide for the Wall and Ceiling Mount Bracket.
Mini-coax connector
GPS antenna
compartment
Warning!: Do not force the connector into the GPS antenna port as this can damage the connector.
Replace the cover on the station. Verify the cable is threaded through the opening on the cover.
8.
9. Rotate the wireless antenna back up to its original position.
Tip: Use double-sided tape to secure the bottom of the GPS antenna to its new location.
Power on the Network Extender for Business.
10.
Note: If necessary please contact Verizon Wireless to obtain a longer GPS cable.
18
GPS antenna
cover