Table of Contents
Advertisement
11. Using a small flat blade screwdriver, press down on the heat sink clip
retention latch and hook it under the fastener tab on the base of the ZIF
socket, as shown in Figure 10, A. The heat sink clip is now secured to the
fastener tab of the ZIF socket.
A
Figure 10. Installing Heat Sink Clip
12. Install a VRM module into the system board. See Figure 11. Position the
module over the socket on the board and press down evenly on the board
until it seats correctly.
Figure 11. Installing the VRM Board
13. Record the processor part number in the equipment log.
120Le Pentium III Processor Installation 11
Advertisement
Table of Contents
