Restart
Perform a system restart as follows:
1. Stop the operating system.
2. Enter
pc
Power On Reset
Perform a power on reset as follows:
1. Stop the operating system.
2. Enter
dn
rotating.
3. At the rear of the system, turn off the Power Bay Unit circuit breakers (see
Figure 2-3).
4. Wait 10 to 15 seconds to discharge residual voltage.
5. Turn on the AC power circuit breaker for Power Bay Unit 0 and for Power
Bay Unit 1(see Figure 2-3).
6. On the SP console, enter the login account and password.
7. On the SP console, enter
processor turns on DC power and initializes the hardware. The BIOS boots
the operating system.
2-10 System Operation
at the SP command prompt.
at the SP command prompt. Check that the main chassis fans stop
up
at the SP command prompt. The service