NEC Express5800 1160Xd User Manual page 102

cmd arg1
check -
mmcxy
clear
Displayed String
nonexist
INVISIBLE
power-off
power-on
offline
online
master
3-46 Service Processor
Table 3-35 HC Subcommands (cont'd)
arg2 arg3 arg4
- - -
rowz
- -
Table 3-36. HC State Display Strings
Description
Indicates that a component is defined as non-existent (i.e. the iSP manages a
component as if it does not exist).
The iSP manages a component as if it exists, but it does not exist when seen
from the iSP due to failure or other reasons.
Once it is recognized by the iSP (regardless of auto detection or manual setting),
it will be managed as if it exists unless you delete it explicitly using the "delete"
command.
Indicates that the power supply (DC) is OFF.
For some components, the power supply (DC) becomes ON when AC is
supplied.
Indicates that the power supply (DC) is ON.
For some components, it is overwritten by the following state display.
Indicates that the power supply (DC) is ON and a component is not configured in
the software (OS or BIOS).
This applies to the CELL Board, XBC Board, PCIX Unit, and their
subcomponents.
Indicates that the power supply (DC) is ON and a component is configured in the
software (OS or BIOS).
This applies to CELL Board, XBC Board, PCIX Unit, and their subcomponents.
This is valid only for the state display of the ISP Board/CLK Board. Indicates that
it is operating as the master.
Description
Checks the current configuration information
from the following points:
Presence of units whose location information
is not entered
Presence of "DISABLE" components
Presence of "INVISIBLE" units
Configuration violating the installation
restrictions
Configuration with penalty in
performance/RAS.
This subcommand can be executed in the AC
POWER ON state or DC POWER ON state.
Clears the memory bit error counters of ROW.
"x" is the physical CELL Board number (0-7).
"y" is the MMC number (0-1) within the CELL
Board.
"z" is the ROW number (0-7).