Troubleshooting - Clarke Log Buster 4 Operation & Maintenance Instructions Manual

Trouble Shooting
Problem
Log fails to split.
Ram advances jerkily or
Log pusher advances
with strong vibrations.
jerkily and/or vibrates
badly.
Oil leaks.
The use of parts other than CLARKE replacement parts may result in safety hazards,
decreased tool performance and may invalidate your warranty.
PARTS: Parts@clarkeinternational.com
SERVICE:
Probable Cause
Incorrect positioning of the
log.
Log exceeds permitted
dimensions or wood is too
hard or knotty for the
capacity of the machine.
Wedge not cutting.
Oil Leak
Air in hydraulic system.
Worn or damaged oil seals.
IMPORTANT:
PARTS & SERVICE TEL: 020 8988 7400
or e-mail as follows:
Service@clarkeinternational.com
-8-
Remedy
Reposition the log.
Use logs of the correct
specifications.
Check the splitting wedge
and sharpen if necessary.
Locate the leak and rectify,
if necessary, contact your
nearest CLARKE dealer.
Bleed system as described
under Maintenance. Top up if
necessary. If problem persists,
consult your CLARKE dealer.
Fit new oil seals, consult your
nearest CLARKE dealer.