Dhcp Host Name Setting - Toshiba B-SX6T SERIES System Mode Manual

2. SYSTEM MODE

2.7.4 DHCP Host Name Setting

After DHPC client ID has been set, the DHCP host name setting menu is displayed.
Press the [PAUSE] key and set the DHCP host name one byte by one byte.
MODE ASCII
DHCP HOST NAME
[PAUSE]
MODE ASCII
Enter a character or a value for each of 1st byte to 16th byte
sequentially using the [FEED] or [RESTART] key.
[PAUSE]
<7>IP ADDRESS
NOTES:
1. Code used to enter a DHCP client ID is selectable between ASCII code (alphanumeric) and Hex. code.
2. Set a character or value for each byte by using the [RESTART] or [FEED] key.
[RESTART] key: Increment
3. Press the [PAUSE] key to enter the next byte. Repeat this until 16th byte is entered.
4. After the 16th byte of the DHCP host name is set, press the [PAUSE] key. At this time, the display will turn to
"<7>IP ADDRESS".
5. A DHCP ID can be used to check what IP address is assigned to which client on a DHCP server. If a DHCP
ID is not assigned, MAC address of a network device (LAN card or LAN interface board) will be notified to the
server as a DHCP ID instead.
A DHCP ID is a 16-byte character string. As "FFH" (hex. code) is recognized as a terminator, if the top byte of
DHCP ID is "FFH", it is considered that a DHCP ID is not assigned.
ASCII code and Hex. code correspondence table
Upper 4 bits
2
Lower 4 bits
0 SP
1 !
2 "
3 #
4 $
5 %
6 &
7 '
8 (
9 )
A *
B +
C ,
D -
E .
F /
SP = Space
When the system mode settings have been completed, turn off the printer.
[FEED] key: Decrement
3 4 5 6 7
0 @ P ` P
1 A Q a q
2 B R b r
3 C S c s
4 D T d t
5 E U e u
6 F V f v
7 G W g w
8 H X h x
9 I Y i y
: J Z j z
; K [ k {
< L \ l |
= M ] m }
> N ^ n
? O _ o
(Example) To enter "TOSHIBA" in Hex. code:
54 4F 53 48 49 42 41
2-69
EO13-33002
2.7 IP Address Setting