Removing, Installing And Cleaning Filters - Whirlpool 11-0086-11 Owner's Manual

MAINTAINING YOUR SPA cont...

REMOVING, INSTALLING AND CLEANING FILTERS

These are the steps needed to successfully replace your filters You
should replace your disposable spa filters and clean your nondispos-
able filters every four months.
1) Turn off all power to your spa and re-
move the filter lid by lifting it out towards
you.
2) Turn the filter counterclockwise and re-
move it from the filter well.
3) Dispose of the used filter.
4) To replace, set screen back into its place
turn clockwise to fasten. DO NOT\ over-tighten.
5) Place the new filter into position and
turn clockwise to fasten. DO NOT over-
tighten.
6) Follow the directions 1) and 2) for the
pleated filter cartridge. You then rinse the
filter with a garden hose and soak the filter
in a mixture of one pint of filter cleaner with
2.5 gallons of water for at least 12 hours.
The filter must be completely submerged. You then follow the directions
4) and 5) to replace the filter
WARNING: Power to your spa must be turned off prior to remov-
ing your filters. The suction at the filter is extremely strong and
can cause injury if there is no filter. NEVER run your spa without
the filters properly installed. Injury to person and damage to the
equipment can occur. Any damage to equipment due to this cir-
cumstance will not be covered under warranty.
32