Basic Programming; Program Key; Setting The Time; Setting Filter Cycle Start Time - Whirlpool 11-0086-11 Owner's Manual

BASIC PROGRAMMING

Program key

Use Program key to display time or enter
Programming menu by pressing and
holding key. In Programming mode, the
following parameters can be set: time, filter
cycle's start time, duration and frequency,
also, Economy mode's start time as well
as its end time and finally the choice of
temperature display unit.

Setting the time

Enter Programming mode by holding Prog.
key pressed down for 3 sec. The display
will show the current time setting.
Setting the hour:
Use (+) or (-) key to change hour setting
(AM/PM).
Setting the minutes:
Press Ok key.
Use (+) or (-) key to change
minutes setting.

Setting Filter cycle start time

To program the filter cycle, you must enter
these parameters: start time, duration and
frequency. During a filter cycle, pumps run
for one minute to purge the plumbing,
then CP runs for the programmed number
of hours and the ozonator is activated.
Press Ok key a second time.
The display will show FSxx, with "xx"
representing the starting hour.
Use (+) or (-) key to change setting (01:00-
12:00 AM / PM).

Setting Filter cycle duration

Setting of the Filter cycle duration in hours.
If no filtering is required, the duration should
be set to "0".
Press Ok key a third time.
The display will show Fdxx, with "xx"
representing the duration in hours.
Use (+) or (-) key to change setting (00:00-
23:00 hrs).
27