Table of Contents
Advertisement
Control reference guide
Recorder rear panel
VIDEO IN connector
(Pin jack)
This is a composite signal input.
VIDEO OUT connector
(Pin jack)
This is a composite signal output.
The signal from the camera cable
connector or the VIDEO IN
connector can be supplied here. For
information on how to select the
signal, see the documentation of the
Toughbook-Arbitrator Front End
Software.
AUDIO IN 1, 2 connectors
(Pin jack)
These are line level signal inputs.
The output signals of audio
components can be connected
here. For details on the connection,
see the installation manual.
MIC IN connector (Pin jack)
This is a microphone level signal
input. For details on the connection,
see the installation manual.
Cable clamp
This clamp can be used to fasten
the video cable, audio cable,
camera cable, and power cable.
(continued)
LAN port
This port allows a 100BASE-TX
connection to a computer. Use the
supplied LAN cable.
Camera cable connector
Use the supplied camera cable to
connect the camera to the supplied
recorder.
GPIO/SERIAL connector
This connector serves as a
combined trigger signal input (8
lines), record tally output (1 line),
and serial port.
DC IN connector
This is the power supply connector.
Note:
Do not disconnect the power cable
while the recorder is operating. In
particular, if the power supply is
interrupted during recording, P2
card managing information and data
setting information may be lost or
damaged.
9
Advertisement
Table of Contents
