Sanyo VR-L4110WSEC - Commercial Solutions Lab Manual page 15

UV Sterilization - Light Indicator
Open Door Indicator
Water Reservoir
Level Indicator
Secondary Over
Temp. Indicator
Over Temp. Safety Shut off Adjustment
Anti-Contamination Measures
• Interior, plenums and shelving
constructed of SANYO's exclusive
inCu saFe , germicidal, copper-
™
enriched stainless steel.
• Optional UV sterilization system
for humidity reservoir.
• Extra heaters positioned on the
outer glass door to eliminate
condensation.
Heater On Indicator CO
Temperature Display
High Humidity Mode Indicator
Horizontal Laminar
Airflow System
SANYO's reach-in incubator's cross-
shelf directed air flow system promotes
optimum temperature uniformity
throughout the chamber and contributes
to quick temperature recovery after door
openings. Utilizing SANYO's exclusive
inCu saFe chamber material in the
™
perforated side plenums helps minimize
contamination concerns and direct posi-
tive and negative pressure air flow.
Horizontal airflow maintains accurate temperature
and CO control and uniformity at all shelf levels,
2
top-to-bottom, front-to-back.
Perforated sidewall panels right (pressure) and left
(negative pressure) assure a positive, gentle airflow
from right to left.
Humidified air minimizes potential for cell culture
media desiccation.
Optional SafeCell
™
decontamination of the humidity reservoir.
Setpoint - Set Temperature and CO
Inject Indicator
2
Calibration - Calibrate air temperature and CO
CO Display
2
Scroll Programming Buttons
UV sterilization system provides
2
2
Optional Built-in CO Tank Switchover System
2
Alarm, Buzzer
Silence
Optional UV Sterilization
and Humidity Selection
SANYO's patented and laboratory
proven Safe Cell UV sterilization system
™
is employed to sterilize the humidifying
water reservoir and help eliminate
contamination concerns. The unit can
be set to both nominal and high
humidity setpoints.
Humidity reservoir heaters are located
on the outside walls of the reservoir
CO recovery after a 60 second door opening
2
and are not as susceptible to corrosion
for the SANYO MCO-80IC
and scaling from water as competitive
5%
systems are. An optional autofill second-
ary tank (Model MCO-80AS) system is
4%
also available to ensure continuous
3%
water supply to the humidity reservoir.
2%
This system employs a large tank
1%
(4.8 gal./18 L), with electronic water level
sensor and autofill solenoid valve.
10 min. 20 min.
Temperature Recovery
37°C
36°C
35°C
34°C
33°C
10 min. 20 min.
Recovery after a 30 second door opening for the
Sanyo MCO-80IC.
CO recovery after a 60 second door opening
2
for the competitor
5%
4%
3%
2%
1%
15