Table of Contents
Advertisement
Error information
Error
No.
Message
E-30
TURN POWER OFF
E-37
COMM ERROR
E-38
SYSTEM ERROR
E-55
OPT SYS ERROR
E-56
OPT NOT RESPONSE
E-57
OPT HALT
E-BA
BATTERY
AVCHD warning information (when the AJ-YCX250G AVCHD codec board (optional) is
installed)
The following lists major warning messages displayed on the LCD monitor and viewfinder. For details on other warning
messages, follow the instructions given in the messages.
Message
CANNOT BE USED DUE TO INCOMPATIBLE DATA.
CANNOT PLAY.
CANNOT SELECT MORE CLIPS.
CANNOT SET. THE NUMBER OF INDEXES HAS EXCEEDED THE
MAXIMUM LIMIT.
CARD ERROR. PLEASE REFORMAT.
CHECK CARD.
CONTROL DATA ERROR HAS BEEN DETECTED.
NO CARD
NO FILE.
REPAIR CLIP?
THE CLIP IS PROTECTED. PLEASE CANCEL PROTECTION.
THUMBNAIL DATA ERROR IS DETECTED.
UNABLE TO FORMAT.
WRITE PROTECT
Displayed when an error occurs in reading and writing card data.
To continue operation, turn the power off and then back on again.
Displayed when a system controller command was not complied to.
To continue operation, turn the power off and then back on again.
Displayed when the fan motor stops.
To continue operation, turn the power off and then back on again.
Displayed when an AJ-YCX250G AVCHD codec board (optional) malfunctions. Turn
the power off and then back on again.
Displayed when an AJ-YCX250G AVCHD codec board (optional) does not respond
to communications. Turn the power off and then back on again.
Displayed when communications from an AJ-YCX250G AVCHD codec board
(optional) cannot be updated. Turn the power off and then back on again.
Appears when the input DC voltage is below the undercut voltage.
This data conforms to a different standard and cannot be used.
Cannot play.
Too many clips selected to delete.
Cannot make settings since the number of indexes exceeds the limit
Formatting failed. This card must be reformatted.
Check the card.
A control data error was detected.
No card is inserted.
The metadata file cannot be found.
Repair clip?
The clip is protected. Cancel protection.
A thumbnail data error was detected.
Cannot be formatted.
The card is write protected.
Description
Description
For Long and Trouble-Free Operation: Error Messages
Operation
STOP
STOP
STOP
STOP
STOP
STOP
STOP
203
Advertisement
Table of Contents
