Contents Of The Setup Mode - Fujitsu fi-4340C Operator's Manual

Contents of the Setup Mode

This section describes the contents of the setup mode.
No Item
1
Double feed check
2
Length check
=No/10/15/20 mm
3
IPC pre-setting
Resetting of
4
abrasion counter
5
Pick start time
setting
6
Time-out limit setting
7
ADF front offset
setting(*2)
8
ADF back offset
setting(*2)
9
Document bed
offset setting(*2)
10
IPC status display
11 Low Power Mode
setting
12 Select Interface
13 Display TPS Board
ID Number
Description
Specifies the double feed detection.
Double feed is detected by checking the
document length and/or paper
thickness.(*1)
Specifies the document length to enable
double feed detection sets the document
length.
Scanner automatically sets the
recommended reading parameters. 3 sets
of parameters are available when IPC-4D
is not installed.
Resets the abrasion counter.
Specifies the time from document Insertion
to the start of picking. User can select the
most comfortable Pick start time for the job.
Specifies the time the scanner waits for
the next document insertion after the last
document was scanned.
Specifies the horizontal and vertical offset
of the front side image when using the
ADF.
Specifies the horizontal and vertical offset
of the back side image when using the
ADF.
Horizontal and vertical offset of the FB
image is specified.
Displays whether or not the image
processing board (IPC-4D) and the
Imprinter option are installed.
Changes the default setting of the duration
for power save.
Selects the interface when the scanner
has a board in the third party Slot.
Displays the ID number of the board which
is installed in the third party Slot.
Selectable
Default
parameters
No/Yes No
Tolerance:
No
No/10/15/20mm
Document:
No
1: Sharpen No
2: Darken Character
3: Copy Quality
--- ---
Time:
1.0 sec
0.2 to 29.8 sec
Time:
27 values from 30 sec
1 to 1999 sec
Offset: Offset:
H:-2 to +3 mm H: 0 mm
V:-2 to +3 mm V: 0 mm
Offset: Offset:
H:-2 to +3 mm H: 0 mm
V:-2 to +3 mm V: 0 mm
Offset: Offset:
H:-2 to +3 mm H: 0 mm
V:-2 to +3 mm V: 0 mm
--- ---
5 min.
15 min.
to 60 min.
Auto/SCSI/Tps Auto
--- ---
G 7-3