Fujitsu fi-4340C Operator's Manual page 42

• Place the documents face down, with the top to the left as shown in A. (The long side is the top for
landscape mode and the short side is the top for portrait mode.)
• Holding both ends with both hands, lift the documents.
• Hold the documents tightly with your left hand and bend them as shown in B.
• Grip the documents tightly with your right hand, loosen the grip of your left hand, and straighten as
shown in C.
• Even up the feed edge of the batch of paper as shown in D.
NOTICE
Reduce the batch size of the documents if double feed or mispick occurs.
NOTICE
Note the following when preparing the paper.
• Remove paper clips and staples. Flatten the staple holes.
•
A preliminary document feed test may be necessary to avoid unexpected errors. If document slip or
jam in the ADF (JAM error) or double feed occurs frequently, read the documents manually using the
Document bed.
The following documents may be difficult to read properly using the ADF:
- Paper with clips or staples.
- Paper written on with wet ink.
- Paper of uneven thickness (for example, envelopes).
- Paper with large rumples or curls.
- Paper with folds or tears.
- Tracing paper.
- Coated paper.
- Carbon paper.
- Paper smaller than A8 (vertical)
G 4-6