Please read this User Manual carefully to ensure proper use of this product and keep this manual for future reference. Important Safety Instructions 1. Read these instructions. 2. Keep these instructions. 3. Heed all warnings. 4. Follow all instructions. 5. Do not use this apparatus near water. 6.
Thisproductcomplieswiththebasicrequirementsandotherrelevantregulationsofdirectives Ce2004/108/eeCand73/23eeC;rohs2002/95eeC THOMSON is a trademark of TECHNICOLOR S.A. used under license to STRONG Europe. Subject to alterations. In consequence of continuous research and development technical specifications, design and appearance of products may change. Freeview is a trade mark owned by or licensed to DTV Services Limited ("DTVS"), all other product names are trademarks or registered trademarks of their...
1.0InsTruCTIon 1.1safetyInstructions donoTInsTallYourreCeIver: In a closed or poorly ventilated cabinet; directly on top of or under any other equipment; on a surface which might obstruct the ventilation slots. donoTeXPoseThereCeIverorITsaCCessorIes: To direct sunlight or any other equipment that generates heat; to rain or intense moisture; to intense vibration and to any shock which may cause permanent damage to your receiver or to any magnetic objects, such as loudspeakers, transformers, etc.
Mainssupply The mains operating voltage is detailed on the rear of the box. The mains lead on this box may be supplied with a moulded plug incorporating a fuse. Should the fuse need to be replaced, an ASTA or BSI approved BS1362 fuse must be used of the same rating.
2.2 f rontpanel 1. sTandbYIndICaTor Used to visually show power state of the set top box, the green LED will be light if turned on the set top box and the red LED will be light if the set top box entered standby mode. 2.
11. Menu Opens the main menu/ in menu you will get one step back 12. eXIT/sorTIe Exits from the menu or sub-menu 13. guIde Shows the EPG (Electronic Program Guide) in TV mode 14. v+/v- Volume up/down 15. ! Mutes audio output of the receiver 16.
2.6usingtheremoteControl To use the remote control, point it towards the front of the digital set top box. The remote control has a range of up to 7 metres from the set top box at an angle of up to 60 degrees. The remote control will not operate if its path is blocked.
4.0userInTerfaCe The eXIT key will close on screen menus. All menus will automatically be removed after 30 seconds unless otherwise stated. 4.1Welcomescreen When the STB is powered up for the first time or is brought out of standby a welcome screen will be displayed.
Page 10
banner will be removed after 4 seconds. In addition you can toggle between ‘Now’ and ‘Next’ information using the t/u keys. To display ‘Next’ information from the ‘Now’ banner, the user press the u key. 4.7.2firstlevel‘next’Information You can return from ‘Next’ to ‘Now’ Information using the t key. A second press of the key will bring up the extended program information, and example is shown below.
Page 11
This banner will stay permanently on the screen when no video can be watched on the TV. This banner will also display the current favourite list enabled and if the service is new or removed. The following messages will be displayed under various circumstances: Channel Change Banner No service are stored in the receiver This service is encrypted...
Page 12
4.7.7dataserviceloading If the TXT key is pressed on a service that contains an MHEG data application and data services have been enabled in the languages menu, then before the application has been fully loaded, this display will be presented. The graphics are displayed in the centre of the screen. This will be automatically removed when the MHEG application acquires the display or will timeout after 60 seconds if the MHEG application fails to launch.
5.0MaInMenu The Main Menu contains the following options. 5.1Channelorganiser Accessed from the main menu, the service list contains the details of the services that have been added into the system. The list can be scrolled through using the p/q keys. The selected channel appears with a yellow border.
Page 14
5.2.1favouritesedit Accessed from the favourites menu. The order of the Favourite list determines the order the programmes appear when the user surfing up and down the channels with the P+/P- keys. The full service list and the favourite list can be scrolled through using p/q. The two lists are selected by using the t/u keys.
5.2.2nameeditor This name editor menu is used to allow you to rename a favourite group. The character selection is done by moving the highlight around a character matrix and using oK to choose the character. The new name is displayed at the top of the menu. CAPS is used to toggle the letters between upper-case and lower-case and Delete is used to backspace/delete the last character.
6.2Tvsetup The TV setup menu will have the following options: TV Setup Menu The options are: Television type: Selects the type of TV screen that the set-top-box is connected to. The options are 4:3 and 16:9. Widescreen: This option is only available when 4:3 is selected in the shape option.
6.3.2ParentallockingviaMenuselection The PIN must be entered to access the Parental Control menu: Enter PIN to access Menu Parental Control Menu The system is supplied with a default PIN. The default Parental control PIN is “0000”. 6.3.3ParentalControlMenu Entering a valid PIN gives access to a sub menu that provides options to change the PIN or Lock and Unlock services 6.3.4ParentallockingChangePIn Selecting the option to change the PIN takes you to a further sub menu that handles the...
Page 18
6.4.1fullscanaddnewservices When the Full Scan Add New Services option is selected, the end of the service list is displayed. When new services are found, they are displayed at the end of the existing list in a highlighted yellow colour. During the scan a progress bar is displayed and a message giving the estimated time remaining to complete the scan.
Page 19
Guard Interval: Selects the required guard interval. The options are 1/4, 1/8, 1/16, and 1/32. Scan: Starts or stops a service scan. Information: Modulation: The modulation type of the locked stream. The values can be QPSK, QAM16 or QAM64. FEC: The FEC rate of the locked stream.
Full Scan Setup Menu 6.4.5firstTimesetup This menu is used to delete all channels and settings to the first time installation, including Language, TV set, Service, Parental Control set, and then show the First time welcome screen. First Time Setup Press oK key to delete all channels and settings, the following menu will be displayed: After initialize, the welcome screen will show After Pressing oK, a full scan replacing existing services screen will be presented.
Page 21
6.5.1updatebyusb This menu for the SW upgrading by USB jack. 1. First Copy the provided *.ssu (for example THT105_version_3.ssu) upgrade file to the root directory of the USB disk and then insert the USB to the USB port of the box, you should see USB indicator flashing while reading.
2.Progress During the download progress a message will be displayed which details to the user any message that the manufacturer requires. This message is broadcast as part of the download and isn’t hard-coded into the interface. The message may describe new features of the download or a contact number in case of download failure.
7.1MyImages My Images can play most JPG/BMP/GIF photos and operate it, if there are photos in device root folder, it will start at Thumbnail mode, otherwise it will start at Folder mode, and ask you to select a folder as below. Thumbnail/Folder The info (Width x Height and date) of selected photo will be displayed at the left bottom at Thumbnail mode.
Music Playing 8.0TroubleshooTIng If you experience problems with this receiver or its installation, please read carefully the relevant sections of this User Manual and this Troubleshooting section. Problem Possiblecause Whattodo Standby light not lit Mains lead unplugged Check mains lead Mains fuse blown Check fuse No signal found...
1.00 W Operating Temperature: 0 ~ 40 °C Storage Temperature: -30 ~ 80 °C Operating Humidity Range: 10 ~ 85 %, RH, non-condensing Size (W x D x H) in mm: 183 x 128 x 46 Net-weight: 0.35 kg eancodeThT105:8717185445923 TeChnICalsPeCIfICaTIons...
Need help?
Do you have a question about the THT105 and is the answer not in the manual?
Questions and answers