Table of Contents
Advertisement
TCP/IP and IP Addresses
If your computer is on a large network, contact your network administrator for the appropriate TCP/IP
addresses and additional system settings information.
If you are creating your own small Local Area Network or connecting the printer directly to your
computer using Ethernet, follow the procedure for automatically setting the printer's IP address.
Computers and printers primarily use TCP/IP protocols to communicate over an Ethernet network.
With TCP/IP protocols, each printer and computer must have a unique IP address. It is important that
the addresses are similar, but not the same; only the last digit needs to be different. For example, your
printer can have the address 192.168.1.2 while your computer has the address 192.168.1.3. Another
device can have the address 192.168.1.4.
Many networks have a Dynamic Host Configuration Protocol (DHCP) server. A DHCP server
automatically programs an IP address into every computer and printer on the network that is
configured to use DHCP. A DHCP server is built into most cable and Digital Subscriber Line (DSL)
routers. If you use a cable or DSL router, see your router's documentation for information on IP
addressing.
Printer Connection and Software Installation
76
Advertisement
Table of Contents
Need help?
Do you have a question about the DocuPrint CM205 f and is the answer not in the manual?
Questions and answers
black toner to light
To fix a light black toner issue on the Fuji Xerox DocuPrint CM205 f, follow these steps:
1. Check Toner Levels:
- Open the Printer Status window in SimpleMonitor.
- Check the toner level in the Consumables tab.
- Replace the black toner cartridge if low or empty.
2. Verify Print Media:
- Ensure the paper is dry and suitable for the printer.
- Use the recommended print media.
3. Adjust Paper Type Setting:
- Open Printing Preferences in the print driver.
- Go to the Paper/Output tab.
- Change the Paper Type setting.
4. Disable Toner Saving Mode:
- Open Printing Preferences in the print driver.
- Go to the Graphics tab.
- Ensure the Toner Saving Mode checkbox is not selected.
If the issue persists after these steps, contact a Fuji Xerox local representative.
This answer is automatically generated