Packard Bell Vibe 300 Disassembly Manual
  1. Manuals
  2. Brands
  3. Packard Bell Manuals
  4. MP3 Player
  5. Vibe 300
  6. Disassembly manual
Packard Bell Vibe 300 Disassembly Manual

Packard Bell Vibe 300 Disassembly Manual

Hide thumbs
Table of Contents

Advertisement

Quick Links

Packard Bell
Vibe 300
Disassembly Manual

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Vibe 300 and is the answer not in the manual?

Questions and answers

Related Manuals for Packard Bell Vibe 300

Summary of Contents for Packard Bell Vibe 300

  • Page 1 Packard Bell Vibe 300 Disassembly Manual...

  • Page 2: Table Of Contents

    Table of Contents Overview Technician Notes Disassembly Instructions Reassembly Instructions Required Tools Removing the Bottom Cover Removing the HDD Removing the Battery Removing the Main Board / LCD Panel Removing the Keypad Reassembly Notes Notice Packard Bell Vibe 300 Disassembly Manual...

  • Page 3: Overview

    Packard Bell reserves the right to make changes to the Vibe 300 MP3 player without notice. Technician Notes Only technicians authorized by NEC Computers International B.V. should attempt to repair this equipment.

  • Page 4: Removing The Bottom Cover

    Note Optionally, remove the FM module clicked into the slot. 3. Remove the four screws. Fig. 2 Screw in FM module compartment. 4. Remove the bottom cover. Packard Bell Vibe 300 Disassembly Manual...

  • Page 5: Removing The Hdd

    Fig. 3 Vibe 300 without bottom cover. Removing the HDD To remove the HDD, first remove the bottom cover (see section Removing the Bottom Cover) and then follow the steps below: 1. Disconnect micro drive (pull drive while holding the flat cable). You can pull the rubber cover from the micro drive, in case you need to replace the micro drive.

  • Page 6: Removing The Main Board / Lcd Panel

    2. Lift the main board and slide it side ways. Keep in mind that it is still connected to the top cover! 3. Disconnect the keypad flat cable: Push the two clips in the indicated direction (see 7) and take out the flat cable. Packard Bell Vibe 300 Disassembly Manual...
  • Page 7 Fig. 8 Disconnecting the HDD flat cable. 6. Disconnect the LCD flat cable from the main board: Push the two clips in the indicated direction (see 9) and take out the flat cable. Fig. 9 Disconnecting the LCD flat cable. Packard Bell Vibe 300 Disassembly Manual...

  • Page 8: Removing The Keypad

    When placing back the main board, push it gently until it clicks into place. If it is not positioned properly, putting back the two side panels will not be possible. While putting back the side covers, carefully check the alignment of the power Packard Bell Vibe 300 Disassembly Manual...
  • Page 9 The micro drive is not keyed and, therefore, it can be inserted up side down. In case you connect the drive the wrong way around, you will see on the display the hard disk symbol with a red cross. Packard Bell Vibe 300 Disassembly Manual...

  • Page 10: Notice

    DAMAGES RESULTING FROM THE FURNISHING, PERFORMANCE, OR USE OF THIS MATERIAL. Copyright © 2005 NEC Computers International B.V. All rights reserved. Packard Bell is a trademark of NEC Computers International B.V. Vibe 300 Disassembly Manual Author: Product Support Consumer - JMCA...

Table of Contents