Table of Contents
Advertisement
TROUBLESHOOTING
If you are having trouble with the digital receiver, check the following items to see if the problem
can be resolved. Sometimes another device is at fault, so be sure to also inspect the other devices
being used. If the trouble still cannot be resolved, contact your nearest PIONEER authorised service
centre, the dealer where you purchased the digital receiver or ONdigital.
Condition
No sound, no picture, and no
front-panel display.
No sound and no picture, but
the front panel is displaying
"--:--."
No sound and no picture, but
the front panel display is cor-
rect.
Only the Main menu, its sub-
menus, and the information
bar are available. Service se-
lection is not possible.
56
<BRB1056>
Possible cause
• The receiver is not plugged in-
to the main power supply or is
not turned on.
• The receiver is in standby.
• Non-digital television is being
viewed via the UHF aerial TV
connection.
• The SCART lead is connected
to the wrong sockets.
• The connections are correct
but the TV is not switched to
an external AV source (AV1 or
EXT 1, etc.).
• The connection cables might
be defective (corroded, bro-
ken, or damaged) or missing.
• A download list of (digital)
services is not stored in the
digital receiver's memory.
• The digital receiver is not cor-
rectly set up for the aerial.
• The aerial is not receiving the
signal.
• The transmitted signal is too
weak.
Measures
• Check the main power sup-
ply connection. Press the
ON/OFF button on the front
of the receiver.
• Press one of the remote con-
troller number buttons to
wake up the digital receiver.
• Press the remote controller
TV/DTV button.
• Check the SCART connec-
tions.
• Check the TV SCART con-
nections.
• Check all connections.
• Follow the relevant installa-
tion instructions contained
in the section
"CONNECTIONS".
• Check if the analogue chan-
nels are received properly
and then check the aerial
connection (aerial to DBR-
T200GB, and TV aerial input
connected to DBR-T200GB
UHF input). Refer to section
"Signal Strength" on page
49.
• Check the aerial installation
and positioning.
• Check the aerial installation
and positioning or install a
larger aerial.
In unusual cases, the effect
can be caused by severe
weather or very heavy cloud
cover.
Advertisement
Table of Contents
