Using Remote Controller With Equipment Of Other Manufacturers - Pioneer DBR-T200GB Instruction Book

USING REMOTE CONTROLLER WITH EQUIPMENT OF OTHER MANUFACTURERS

The remote controller can directly control the televisions and VCRs of other major brands. When
the remote controller power is first turned on it is programmed for PIONEER brand TVs and VCRs,
but if you will use a TV or VCR of another major brand, follow the instruction below to setup the
remote controller.
TV ID code setup
This is used for TVs only.
Press and hold down the remote controller
ton for TV at the bottom right while entering the
4-digit code for the brand of the TV being used.
(Refer to the included code list.)
Press the
turn on the TV and put it in standby.
IMPORTANT:
It might not be possible to use the remote controller to directly
control some TVs.
VCR ID code setup
This is used for VCR only.
Press and hold down the remote controller
ton for VCR at the bottom left while entering the
4-digit code for the brand of the VCR being used.
(Refer to the included code list.)
Press the
turn on the VCR and put it in standby.
IMPORTANT:
It might not be possible to use the remote controller to directly
control some VCRs.
Resetting the remote controller to the default settings
If necessary, the remote controller can be reset to the factory default settings by clearing all of the
programmed codes.
To do this, press code 9999 while pressing and holding the remote controller
stores all devices to their default settings.
Status during battery replacement
The remote control information preservation time during battery replacement is about 1 minute.
The buttons will not respond while the batteries are being replaced. When the batteries have been
dead or removed for more than 1 minute the brand settings will return to their default values.
IMPORTANT:
Although the PIONEER remote controller is compatible with most major brands, PIONEER can-
not guarantee the remote controller operation will be compatible with all TV's or VCR's.
CAUTION
• When setting the brand code, ensure not to direct the remote controller to any other TVs, VCRs
and so forth, because there is always a possibility that such equipment on hand may be oper-
ated.
button to check if the remote controller can be used to
button to check if the remote controller can be used to
but-
but-
button. This re-
51
<BRB1056>