Using The Key Operator Programs - Sharp AR-C260P Key Operator's Manual

Using the key operator programs

The general procedure for using key operator programs is explained below, using "KEY OPERATOR CODE
CHANGE" as an example.
NOTE
To use the key operator programs, you must first program a key operator code number. (See steps 3 and 4 below.)
1 Press the [MENU] key repeatedly until
"KEY OPERATOR PROGRAMS" appears.
Press the [OK] key.
2
ENTER KEY OPERATOR
CODE -----
Press the [ ] or [ ] key repeatedly until
3
the first digit of your key operator code
number appears, and then press the [OK]
key.
ENTER KEY OPERATOR
CODE 0----
When you press the [OK] key to enter the first digit
after selecting it, "-" in the first digit will change to
" " and "-" in the second digit will blink. If you need
to correct the previous digit, press the [BACK/C]
key to move back.
4 Repeat step 3 to enter the second through
the fifth digits of your key operator code
and then press the [OK] key.
5 Press the [ ] or [ ] key until the desired
program appears and then press the [OK]
key.
This message will
appear.
The factory default
setting for the key
operator code number is
00000.
Example:
To change the key
operator code number,
select "KEY
OPERATOR CODE
CHANGE" and then
press the [OK] key.
KEY OPERATOR PROGRAM LIST
6 Press the [ ] or [ ] key to select the
desired setting for the program, and then
press the [OK] key.
Example:"KEY OPERATOR CODE CHANGE" is
selected
In this example, the key operator code is changed
from 0000 (the factory default code) to 98765.
Select "KEY OPERATOR CODE CHANGE" in step 6
and press the [OK] key. The display shows the
following:
SET CODE
00000 - -----
Follow steps 1 through 5 below to enter 98765.
Press the [ ] or [ ] key until 9 appears and then
1
press the [OK] key. The second "-" begins to
blink.
SET CODE
00000 - 9----
Press the [ ] or [ ] key until 8 appears and then
2
press the [OK] key. The third "-" begins to blink.
SET CODE
00000 - 98---
Press the [ ] or [ ] key until 7 appears and then
3
press the [OK] key. The fourth "-" begins to blink.
SET CODE
00000 - 987--
Press the [ ] or [ ] key until 6 appears and then
4
press the [OK] key. The fifth "-" begins to blink.
SET CODE
00000 - 9876-
Press the [ ] or [ ] key until 5 appears and then
5
press the [OK] key.
SET CODE
00000 - 98765
The key operator code changes to the new code.
7 To exit the program, press the [MENU] key.
The settings of each
program are explained
on page 6 and following.
3