NEC Express5800 series User Manual page 129

On-screen message
The following VDs are missing: xx
If you proceed (or load the configuration utility),
these VDs will be removed from your configuration.
If you wish to use them at a later time, they will have
to be imported. If you believe these VDs should be
present, please power off your system and check
your cables to ensure all disks are present.
Press any key to continue, or 'C' to load the
configuration utility.
All of the disks from your previous configuration are
gone. If this is an unexpected message, then please
power off your system and check your cables to
ensure all disks are present.
Press any key to continue, or 'C' to load the
configuration utility.
The cache contains dirty data, but some VDs are
missing or will go offline, so the cached data can not
be written to disk. If this is an unexpected error, then
please power off your system and check your cables
to ensure all disks are present. If you continue, the
data in cache will be permanently discarded.
Press 'X' to acknowledge and permanently destroy
the cached data.
Invalid memory configuration detected. Please
contact your system support.
System has halted.
RAID Adapter
FW Failed Validation!!!
Adapter needs to be reflashed.
Press any key to continue.
Cache data was lost due to an unexpected power-off
or reboot during a write operation, but the adapter
has recovered. This could be due to memory
problems, bad battery, or you may not have a battery
installed.
Press any key to continue or 'C' to load the
configuration utility.
Entering the configuration utility in this state will
result in drive configuration changes. Press 'Y' to
continue loading the configuration utility or please
power off your system and check your cables to
ensure all disks are present and reboot.
Multibit ECC errors were detected on the controller.
DIMM on the controller needs replacement. If you
continue, data corruption can occur. Press 'X' to
continue or else power off the system and replace
the DIMM module and reboot. If you have replaced
the DIMM please press 'X' to continue.
Troubleshooting 8-5
Action
Check if cable and hard disk drives are
connected properly. If the same error
persists, contact your service
representative.
Check if cable and hard disk drives are
connected properly. If the same error
persists, contact your service
representative.
NOTE: If you press X, the data in cache
memory will be lost.
Contact your service representative to
replace the RAID Controller.
Contact your service representative to
replace the RAID Controller.
Check if battery for RAID Controller is
connected properly.
If the same error persists, contact your
service representative to replace the RAID
controller and battery for RAID Controller.
Check if hard disk drives are connected
properly. If the same error persists, contact
your service representative.
Contact your service representative to
replace the RAID Controller.