Removing Peer-To-Peer Software; Removing P2P-Ipx; Replacing The Ozone Filter; Parallel Printing Problems - NEC SuperScript 4400 series User Manual

R P
EMOVING EER
S
OFTWARE
Revises page 81 of the User's Guide.

Removing P2P-IPX

To remove the IPX peer-to-peer software from your
computer, use the Peer-to-Peer-IPX Uninstall program. Follow
these steps.
1. Insert the SuperScript 4400 Series CD into the CD-ROM
drive.
2. From the Windows Start button and select Run to open
the Run dialog box.
3. Type in <CD drive>:\P2PIPX\UNINSTAL.EXE
4. Click OK.
5. Follow the instructions presented by the Uninstall
Wizard.
R
EPLACING THE
Revises page 101 of the User's Guide.
Part Number 126164
The Ozone Filter needs to be replaced about every 12 months.
1. Slide open the Filter Cover located in back of the printer.
- -P
TO EER
O F
ZONE ILTER
2. Take the used Ozone Filter from inside the Filter Cover
and discard it.
3. Fit the new Ozone Filter inside the Filter Cover and slide
it shut.
note:
An odor will come from the ozone filter if not
replaced regularly.
P P
ARALLEL RINTING
Added to Chapter 9, "Troubleshooting."
This section describes solutions to problems that might
appear when a computer is locally connected (with a parallel
cable) to the printer. Only Windows and UNIX computers
can be locally connected.

Nothing Printed

The printer does not indicate that a print job was received
and nothing was printed.

Solution

Assure the bidirectional parallel cable is attached securely.

Nonsense is Printed

This symptom appears as content that appears cryptic and
does not make any sense.
Solution
• Assure that an IEEE 1284 compliant bidirectional cable is
used.
• Assure that the computer provides an IEEE 1284
compliant parallel port.

Error Messages with Little or Nothing Printed

This may be a data communications problem between a
Windows 95 or higher computer and the printer.

Solutions for Windows 95 or Higher Computers

One of, or a combination of the following solutions may
resolve the problem.
• With the printer driver open, click the Details tab to
move it to the front. Click Spool Settings to open the
Spool Settings dialog box. Clear the Disable
bidirectional support for this printer

Removing Peer-to-Peer Software

P
ROBLEMS
radio button.
7