Changing The Jets; To Change The Main Jet - Miele CS 1011 Operating And Installation Instructions

Conversion to another type of gas

Changing the jets

Disconnect the gas hob from the
mains electricity supply. Turn off the
gas supply.
To change the jets, the burner securing
screws must first be loosened and the
upper section of the appliance
removed.

To change the main jet

^ Remove burner caps gh, burner
ring i and burner head j.
^ Pull the control knob off.
^ Loosen screws n.
54
^ Carefully remove the upper section of
the appliance. When doing this make
sure you do not also pull out the light
unit for the display
underneath the upper section. To
release the unit, squeeze together
the two clamps
^ Whilst counterholding it in place with
an SW 13 spanner, unscrew the main
jet anti-clockwise from its housing
using an SW 10 spanner (see
illustration).
^ Screw in the new main jet,
counterholding the housing again
with the SW13 spanner.
located
.