Table of Contents
Advertisement
SETTING THE FUNCTIONS
RS-232C SET
BAUD RATE
COMMAND TYPE Selects RS-232C command type.
•
Select A for normal setting. Depending on the connected
equipment, select B.
RESPONSE
OFF
ON
ERROR RESPONSE
NORMAL
ILLEGAL
INVALID
ALL
KEY SET
MEMORY KEY FUNC
NORMAL
MEMORY&PRINT
R1
R2
R1
Source
Display
Remote terminal input
40
Selects the baud rate and command type,
etc.
Sets data transmission rate (baud rate) of the
serial communication. Select a proper baud
rate for the connected device.
Selects whether this unit sends RS-232C
response to the host computer or not.
Does not send response.
Sends normal response.
Selects the response code when an
error occurs.
Sends the regular response.
Sends "job end" even if ILLEGAL error
occurs.
Sends "job end" even if INVALID error occurs.
Sends "job end" when any error occurs.
Sets the button functions, remote terminal
functions, etc.
The MEMORY button functions individually.
The image is memorized without printing.
Automatically prints after memorizing.
Do not change the setting of MULTI IMAGE
after memorizing an image.
When a signal inputted through a memory
key (pin No.2) of the remote terminal on the
rear panel is switched to "low" level from
"high" or the MEMORY button on the front
panel is pressed for the fi rst time, a memory
image is displayed. Then at the second time,
a source image is displayed without printing
the memory image.
When a signal inputted through a memory
key (pin No.2) of the remote terminal on the
rear panel is switched to "low" level from
"high" or the MEMORY button on the front
panel is pressed for the fi rst time, a memory
image is displayed. Then at the second time,
a source image is displayed and the memory
image is printed.
source
Memory
Memorizing
Not printing
R2
source
Display
Remote terminal input
Memory
source
Memorizing
Printing
Advertisement
Table of Contents
