When 2U Ac Outlet Box Is Installed - Fujitsu Eternus DX60 User Manual
Disk storage system
Hide thumbs
Also See for Eternus DX60:
- User manual (239 pages) ,
- Operation manual (119 pages) ,
- Product introduction (19 pages)
Table of Contents
Advertisement
Chapter 6 Cable Connection
6.7 Power Cord Connection
6.7.3
When 2U AC Outlet Box is Installed
The following explains how to connect the power cord when 2U AC outlet box is installed.
IMPORTANT
Procedure
1
2
To help with power cord management and prevent incorrect connections,
attach labels to the power cords and make a note of connection origins and
destinations.
Remove the power cord clamp from the AC outlet box.
Loosen the two thumb screws on both sides of the power cord clamp to remove it.
Power cord clamp
Connect the AC outlet box outlets and power supply unit inlets with power cord
(AC output cables) (4m).
The procedures to connect the power supply unit is the same as the
No AC Outlet Box" (page
Each enclosure has two power supply units (PSU#0 and PSU#1).
IMPORTANT
The power cords must be connected to the inlets of both power
supply units.
ETERNUS DX60/DX80/DX90 Disk storage system User Guide
Copyright 2011 FUJITSU LIMITED
125).
132
Step 1
in
"6.7.1 With
P3AM-3042-08ENZ0
Advertisement
Table of Contents
