I Nstalling The (O Ptional ) A Ntenna; Nstalling The Elt Lip - Kenwood NEXEDGE NX-200 Instruction Manual

i
nStAlling the
Screw the antenna into the
connector on the top of the
transceiver by holding the
antenna at its base and turning
it clockwise until secure.
i
nStAlling the
If necessary, attach the belt clip
using the two supplied 3 x 8 mm
binding screws.
Note: If the belt clip is not
installed, its mounting location
may get hot during continuous
transmission or when left sitting in
a hot environment.
Do not use glue which is designed
to prevent screw loosening when
installing the belt clip, as it may
cause damage to the transceiver.
Acrylic ester, which is contained
in these glues, may crack the
transceiver's back panel.
8
(o ) A
ptionAl
B c
elt lip
ntennA
Optional
antenna
Belt clip
Binding screws