Table of Contents
Advertisement
PREPARE
THE
HOOD
Non-Ducted
Installations
Only:
Requires a Performance
Ring to be attached to the blower
wheel. The Performance
Ring is packed behind the Teflon :_-
Coated Bottom Cover.
To install ring:
1, Remove Retaining Ring using a flat blade screwdriver.
Set aside for later. Remove the Blower Wheel by rocking
it side to side and applying a slight force to pull wheel
from motor. Turn the Blower Wheel over.
5. Check that wheel is properly
positioned
as shown.
Press Sections into place if necessary. Make sure wheel
turns freely.
Note: For information on non-ducted filters, see page 9.
BLOWER
SMALL DIAMETER
RETAINING
RING
WHEEL
END
2.
Slide the Performance
Ring onto the Small Diameter
End of the blower wheel and down to the Stop Edge of
the wheel.
3m
4.
Reassemble wheel to motor. Make sure Tab on wheel
fits into one of the Motor Slots.
Push wheel down until it is locked in place. Replace
Retaining
Ring froln Step 1. Be sure it is within the
upper and lower tabs.
MOTOR SLOTS
STOF
EDGE
PERFORMANCE
RING
CONNECT
WIRING
To reduce
the risk of electric
shock,
make
sure power
is switched
off at the service
panel.
Lock
or
tag service
panel
to prevent
power
from
being switched
on accidentally.
1 Connect
House
Wiring
(120 VAC) to hood. Use a piece
of cardboard
to protect
the cooktop,
if necessary.
HOUSE
WIRING
(120 VAC)
2 Connect house black to hood black wire, house white to
hood white wire and house ground under Green Ground
Serew. Securely tighten cable clamp onto house wiring.
GREEN
GROUND
"SCREW
CARDBOARD
protect
cooktop)
Advertisement
Chapters
Table of Contents
