Table of Contents
Advertisement
DRAIN FACiLiTY
The recommended
height of the standpipe
is 18 in/46 cm.The drain hose must be routed through
the
drain hose clip to the standpipe.
Standpipe
must be large enough
to accept the outside diameter
of the
drain hose.The drain hose is attached at the factory.
FLOORING
For best performance,
your Washer must be installed on a solidly constructed
floor. Wood floors may
need to be reinforced
to minimize
vibration
and/or unbalanced
load situations. Carpeting
and soft tile
surfaces are contributing
factors in vibration
and/or tendency
for your Washer to move slightly during
the spin cycle.
Never install your Washer on a platform
or weakly supported
structure.
LOCATION CONSiDERATiONS
Do not install your Washer in areas where water may freeze, since your Washer wiil always maintain
some water in its water valve, pump, and hose areas.This can cause damage
to belts, pump, hoses and
other components.
Operating
temperature
should be above 60°F/16°C.
ALCOVE OR CLOSET INSTALLATION
M[N[ML_M CLEARANCES FOR CLOSETAND ALCOVE INSTALLATIONS:
Sides - I in / 25 mm
Rear - 2.375 in / 60 mm
Top - 17 in/432
mm
Closet Front - 2 in / 51 mm
If both Washer and Dryer are installed together,
the closet front must have at least 72 in 2 or 465 cm 2 of an
unobstructed
air opening.Your
Washer alone does not require a specific air opening.
SAMSUNG
CIothesWasherOwner'slnstructions
A-3
Hide quick links:
Advertisement
Table of Contents
