Table of Contents
Advertisement
Using Two VCRs for Copying
and
Editing Tapes
Use one VCR as the playback
VCR and the other as the
recording
VCR.
1.
Turn on theTV and VCRs.
2.
Tune theTV to theVCR viewing channel (either 3, 4, orTV's
video input).
3.
If you connected your VCR using the ANTENNA jacks, tune
recording VCRto channel 3 or 4--the one selected on the
back of the playback VCR.
If you connected your VCR using the audio/video jacks, press
INPUT on the recording VCR's remote to select the line
input.
4.
Insert the tape you want to copy into the playbackVCR.
Insert a blank tape with safety tab in place into the
recording VCR.
5..When
you reach the point on the tape or program where you
want to begin copying, press PLAY.PAUSE and then
PLAY.PAUSE again on the playback VCR.You may need to
adjust the tracking.
6.
Press the RECORD button, then press PLAY.PAUSE, on the
recording VCR.
7.
Press the PLAY.PAUSE buttons on both VCRs at the same
time to begin copying the tape.
8.
To edit segments that you do not want to copy:
•
Press PLAY.PAUSE on recording VCR to stop copying.
•
Locate the next segment you want to copy on playback
VCR by using FWD, REV, and PLAY-PAUSE, and then
press PLAY.PAUSE.
•
Press PLAY-PAUSE on both VCRs at the same time to
resume copying.
9.
Press STOP.EJECT on both VCRs when you are finished.
Caution:
Two VCR Connection
CABLE BOX
OR_ANTENNA
PLAYBACK VCR
AUDIO
VIOEO
IN FROM
OUT
ANT.
VHFNHF
IN 1
{_"
RECORDING VCR
OUT
AUDIO
27
Advertisement
Table of Contents
