Table of Contents
Advertisement
Resource Configuration Add-in (RCA) Window
The RCA provides three major functions:
n Creates representations of devices that cannot be discovered by the system (ISA
cards)
n Modifies the contents of the system by adding and removing devices
n Modifies the resources used by devices.
You can use the RCA window to define an ISA card or add an ISA card by clicking on the
appropriate button. Removing an ISA card requires that the card be highlighted in the
Devices section of the screen before clicking on the button.
From the SSU main window, launch the RCA by selecting the "Resources" task under
1.
the RCA heading in the task box. Click OK.
2.
When the RCA window appears, it displays messages similar to the following:
Baseboard: System Board
PCI Card: Bus 00 dev 00 -- Host Processor Bridge
PCI Card: Bus 00 dev 0D –- Multifunction Controller
PCI Card: Bus 00 dev 0F –- Ethernet Controller
PCI Card: Bus 00 dev 12 –- SCSI Controller
PCI Card: Bus 00 dev 14 –- VGA Controller
3.
To configure a device, select its name in the Devices section of the RCA window, and
press the spacebar or double-click on it.
Make configuration changes and click on OK to return to the RCA window. Repeat
4.
Steps 3 and 4 to configure additional devices.
5.
Save all the changes made by clicking on the Save button. Saving writes your current
configuration to nonvolatile storage where it will be available to the system after every
reboot.
6.
Close the RCA window and return to the Main Menu by clicking on the Close button.
RCA Window
System Setup Utility B-7
Advertisement
Table of Contents
Troubleshooting
