Troubleshooting - Cub Cadet SERIES 1000 LT1042 Operator's Manual

Hydrostatic lawn tractor
Table of Contents

Advertisement

SECTION 11: TROUBLESHOOTING
Trouble
Engine fails to start
Engine runs erratic
Possible
Cause(s)
PTO/Blade Engage knob engaged.
Parking brake not engaged.
Spark plug wire(s) disconnected.
Throttle control lever not in correct
starting position.
Choke not activated
Fuel tank empty, or stale fuel.
Blocked fuel line.
Faulty spark plug.
Engine flooded.
Unit running with CHOKE activated.
Spark plug wire(s) loose.
Blocked fuel line or stale fuel.
Vent in gas cap plugged.
Water or dirt in fuel system.
Corrective
Action
Place knob in disengaged (OFF) position.
Engage parking brake.
Connect wire to spark plug.
Place throttle lever to FAST position.
Dirty air cleaner.
Engine overheats
Engine oil level low.
Air flow restricted.
Engine hesitates at high RPM Spark plug gap too close.
Idles poorly
Spark plug fouled, faulty or gap too
wide.
Dirty air cleaner.
Replace air cleaner cartridge/element
or clean
pre-cleaner.
Excessive vibration
Cutting blade loose or unbalanced.
Tighten blade and spindle. Balance blade.
Damaged or bent cutting blade.
Replace blade.
Mower will not mulch grass
Engine speed too low.
Place throttle in FAST (rabbit) position.
Wet grass.
Do not mow when grass is wet; wait until later to cut.
Excessively high grass.
Mow once at a high cutting height, then mow again at
desired height or make a narrower cutting swath.
Dull blade.
Sharpen or replace blade.
Uneven cut
Deck not balanced properly.
Perform side-to-side deck adjustment.
Dull blade.
Sharpen or replace blade.
Uneven tire pressure.
Check tire pressure in all four tires.
Pull out the CHOKE control.
Fill tank with clean, fresh (less than 30 days old) gas.
Clean fuel line or replace fuel filter.
Clean, adjust gap or replace plug.
Crank engine with throttle in FAST position.
Push CHOKE control in.
Connect and tighten spark plug wire(s).
Clean fuel line; fill tank with clean, fresh (less than 30
days old) gasoline. Replace fuel filter, if so equipped.
Clear vent or replace cap if damaged.
Drain fuel tank. Refill with clean, fresh (less than 30
days old) gasoline.
Replace air cleaner paper element or clean foam
precleaner.
Fill crankcase with proper capacity and weight of oil.
Clean grass clippings and debris from around the
engine's cooling fins and blower housing.
Remove spark plug and reset the gap.
Replace spark plug. Set plug gap.
27

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents