Table of Contents
Advertisement
Available languages
Available languages
TROUBLESHOOTING
Before performing any type of maintenance/service, disengage all controls and stop the engine. Wait until all moving parts have come to a complete stop.
Disconnect the spark plug wire(s) and negative battery cable to prevent unintended starting. Always wear safety glasses during operation or while performing
any adjustments or repairs.
This section addresses minor service issues.
Problem
Excessive vibration
Uneven cut
Mower will not mulch grass
Engine fails to start
PRODUCT CARE
Cause
1.
Cutting blade loose or unbalanced.
2.
Damaged or bent cutting blade.
1.
Deck not properly leveled.
2.
Cutting blade dull or damaged.
3.
Uneven tire pressure.
1.
Engine speed too low.
2.
Wet grass.
3.
Excessively high grass.
4.
Dull blade.
1.
PTO/Blade engaged.
2.
Blown fuse.
3.
Parking brake not engaged.
WARNING
1.
Tighten blade and spindle.
2.
Replace blade.
1.
Perform side-to-side deck adjustment.
2.
Sharpen or replace cutting blade.
3.
Check and correct tire pressure in all four tires.
1.
Place throttle in FAST (rabbit) position.
2.
Do not mulch when grass is wet.
3.
Mow once at a high cutting height, then mow again at
desired height or make a narrower cutting swath.
4.
Sharpen or replace blade.
1.
Place blade engage lever in disengaged (OFF) position.
2.
Replace fuse(s). Replace with same rating fuse,
if necessary.
3.
Engage parking brake.
See Engine Operator's Manual.
37
Remedy
Advertisement
Table of Contents
