4-1/2"
(114.3
mm) and 5" (127
mm)
Grinding
Wheels
Type 27 guard
Quick-Change
backing flange
Type 27 depressed
center wheel
threaded clamp nut
Type 27 guard
Type 27 hubbed wheel
Attaching
Side
Handle
(FIG.
2)
The side handle (I)can be fitted to either side of the
gear case in the threaded holes, as shown. Before
using the tool, check that the handle is tightened
securely. Use a wrench to firmly tighten the side
handle.
FIG. 2
I
6" (152
mm)
Grinding
Wheels
Type 27 guard
stamped steel
Quick-Change
backing flange
Type 27 depressed
center wheel
threaded clamp nut
Type 27 guard
Type 27 hubbed wheel
Rotating
the
Gear
Case
1. Remove guard and flanges from tool.
2. Remove the four corner screws attaching the gear case to motor
housing.
3. Separating the gear case from motor housing not more than 1/4"
(6.35 mm), rotate the gear case head to desired position.