GE AEM12 Series Owner's Manual And Installation Instructions page 5

ge.corn
Cool Mode
Use file Coohnode at Low, Med, High or Auto Fan
Speed for cooling. Use the Temperature Increase • /
Decrease• pads to
set
the desired
mmperature
between 64°F and 86°F in 1°F increments.
An electronic dlemlostat is used to maintain die
room temperature. The compressor will cycle on
and off m keep the room at the set level of comfort.
Set the fllemlosmt at a lower number and the indoor
air will become coolex. Set the tllemK_stat at a higher
nttmber and the indoor air will become wamleL
NOTE: ff theair conditioner i s off andis thenturnedon
whileset toa Coolsettingor if turnedfroma fansetting
toa Coolsetting,it maytakeapproximately 3 minutes
forthecompressor to startandcoolingtobegin.
CoolingDescriptions
ForNormalCooling--Selectthe Coolmode and
High or Med fan with a middle set temperature.
For Maximum Cooling--Select the Cool mode
and High fan with a lower set temperature.
ForQuieter& NighttimeCooling--Select the
Coolmode and LOW fan with a middle set
temperature.
Do Not Operate in FreezingOutdoorConditions
This cool-only air conditioner was not designed for
freezing outdoor conditions. It
Illttst not
be used in
freezing outdoor conditions.
Energy Saver Mode
Controls the fan.
0N--The fan will cycle on and offwidl tlle
compressoL This results in wider vaIiafions of room
mmpetaUne and humidil),. NormaUy used when the
room is unoccupied.
NOTE: Thefan may continue to run
for a short time after the compressorcgcles off.
OFF--The fan runs all the time, while die
compressor cycles on and off.
Fan Only Mode
Use the FanOnlyMode at Low,Medor Highfan
speed to provide air circulation and filtering
without cooling. Since fan only settings do not
provide cooling, a Set temperaune cannot be
enmred. The room mmpemutre will appear
in the display.
NOTE: AutoFanSpeed cannot b e usedwhenin the
Fan OnlyMode.
Auto Fan Speed
Set to Auto fan speed for die fan speed to
attmmaficMly set m die speed needed m provide
optimum comfort settings with the set temperautre.
If file room needs more cooling, file fan speed
will attmmadcally increase. If the room needs less
cooling, the fan speed will attmmatically decre_kse.
NOTE: AutoFanSpeed cannot b e usedwhenin the
Fan OnlyMode.
Air Direction
Use die levers m adjust die air direction left and
right.
Fingertip pressure on die louver banks adjusts the
air direction up or down.
Remote Control
To ensure proper operation, aim file remora
conUol at the signal receiver on the air
condifione_.
The remote conuol signM has a range of
lap m 20 feet.
Make sure nodfing is between die air conditioner
and the remora conuol that could block the
sigmal.
Make sure batteries are flesh and instaUed
correcdy as indicated on tile remora conuol.
5