Generator Adapter Cord Set - Craftsman 580.325650 Operator's Manual

120 Volt AC, 20 Amp, Duplex Receptacles
Eachduplex receptacleis protected against overload by a
double pole rocker switch circuit breaker.
How to Use the Battery Charoer
Use battery charger jack to keepthe starting battery charged
and ready for use. Battery charging should be done in a dry
location, such as inside a garage.
1. Plug charger into unit's "12V DO Battery Charger" jack,
which is located on generator side panel. Plug battery
charger into a 120 Volt AC wall receptacle.
Use each receptacleto operate 120 Volt AO,single-phase,
60 Hz electrical loads requiring up to 2,400 watts (2.4 kW) at
20 Amps of current. Use cord sets that are rated for 125 Volt
AO loads at 20 Amps (or greater).
Generator Adapter Cord Set
The generator comes with a 25' generator adapter cord set
designed to provide two sets of 120 Volt, 20 Amp outlets
from one 120 Volt, 20 Amp duplex receptacle.
2. Unplug charger from unit and wall outlet when generator'
is being started and while in operation.
3. Keepcharger plugged in when generator is not in useto
prolong battery life. The charger has a built in float
equalizer and will not overcharge battery, even when
plugged in for an extended period of time.
IMPORTANT:See Battery Maintenancefor additional
information.
The maximum load on each outlet is 20 Amps. The maximum
total load on both black wire outlets or white stripe wire
outlets is 20 Amps.
NOTE:Follow all safety precautions when connecting any
extension cord or device to the generator.
13