Battery Pack - Craftsman 315.114280 Operator's Manual

_ WARNING:Donotallowfamiliarity withtoolsto
makeyoucareless. Remember thata careless
fractionofa second issufficient t o inflictserious
injury.
,_ WARNING: Always wear safety goggles or safety
glasses with side sMelds when operating tools.
Failure to do so could result in objects being thrown
into your eyes, resulting in possible serious injury.
APPUCATmONS
You may use this tool for the following purposes:
[] Sawing non-ferrous metal, sheet steel, wood, plastic,
and similar materials.
[] Cutting wood surfaces.
[] Cutting thin sheet metal.
[] Cutting plastics and laminates.
CAUTION: To prevent damage to the battery pack,
remove the battery pack from the charger immedi-
ately if no LED comes on. Return the battery pack
and charger to your nearest service center for check-
ing or replacing. Also, if you are removing the battery
pack from the charger and no LEDs are on, return
both the battery pack and the charger to your near-
est service center. Do not insert another battery pack
into the charger. A damaged charger may
damage a battery pack.
LED FUNCTmONS OF CHARGER
LED WILL BE ON TO mNDmCATE STATUS OF
CHARGER AND BATTERY PACK:
[] Red LED on = Fast charging mode.
[] Green LED on = Fully charged and in trickle charge
mode.
[] Green LED on = When battery pack is inserted into
charger, indicates hot battery pack or that battery pack
is out of or below normal temperature range.
[] Yellow and Green LEDs on = Deeply discharged or
defective battery pack.
[] No LED on = Defective charger or battery pack.
CHARGmNG THE BATTERY PACK
Battery packs for this tool have been shipped in a low
charge condition to prevent possible problems. Therefore,
you should charge it until the green LED on the front of the
charger comes on.
NOTE: Batteries wil! not reach full charge the first time
they are charged. Allow several cycles (operation followed
by recharging) for them to become fully charged.
CHARGmNG A COOL BATTERY PACK
See Figure 2.
If battery pack is below normal temperature range, the
green LED on charger wil! come on. Allow battery pack to
reach normal temperature, then the red LED will come on.
NOT'E: If the charger does not charge the battery pack
under normal circumstances, return both the battery pack
and charger to your nearest Sears Repair Center for
electrical check.
BATTERYPACK
CHARGER
[] Charge the battery pack only with the charger provided.
[] Make sure the power supply is normal household
voltage, 120 volts, 60 Hz, AO only.
[] Connect the charger to the power supply.
[] Place the battery pack in the charger aligning raised rib
on the battery pack with the groove in the charger.
RED LEO ONINDICATES
FASTCHARGING MODE
GREENLEO ONAFTERFAST
CHARGINGCYCLE,INDICATESFULLY
CHARGED BATTERY PACK AND IN
TRICKLECHARGEMODE
YELLOWAND GREEN LEDS ON
INDtCATE$DEEPLYDISCHARGED
OR DEFECTIVEBATTERY PACK
BACKStOE OFCHARGER
Fig. 2
10