Packing List; Removing Battery Pack - Craftsman 315.114233 Operator's Manual

KNOW YOUR TRiM SAW
See Figure 1.
Before attempting to use this product, familiarize yourself
with all operating features and safety rules.
SWITCH
The saw is equipped with a lock=off button which reduces
the possibility of accidental starting. The lock=off button is
located on the handle above the switch trigger. You must
depress the lock=off button in order to pull the switch
trigger. The lock resets each time the trigger is released.
NOTE: You can depress the lock=off button from either the
left or right side.
LASER GUmDE
The laser guide will generate a red colored line on the
work surface when turned on.
SPINDLE LOCK BUTTON
Depressing the spindle lock button witl allow you to install
or replace the saw blade without the spindle turning.
Press the spindle lock button and use the blade wrench to
tighten or loosen the blade screw.
LOWER BLADE GUARD
The lower blade guard will protect the saw blade when the
saw is not in use. it will rotate out of the way when making
a cut.
LOWER BLADE GUARD HANDLE
The lower blade guard has a handle attached to it allowing
you to rotate the lower blade guard out of the way to
instal! or replace the saw blade. It is also used when
making a pocket cut to expose the saw blade.
UNPACKING
This product requires assembly.
[] Carefully remove the tool and any accessories from the
box. Make sure that all items listed in the packing list
are included.
[] inspect the tool carefully to make sure no breakage or
damage occurred during shipping.
[] Do not discard the packing material until you have
carefully inspected and satisfactorily operated the tool.
[] if any parts are damaged or missing, please call
1=800=932=3188 for assistance.
PACKING LiST
Cordless Trim Saw
Battery Pack
Charger
Blade
Blade Wrench
Laser Batteries
Case
Operator's Manual
_ WARMNG: if any parts are missing do not operate
this tool unti! the missing parts are replaced. Failure
to do so could result in possible serious personal
injury.
_ WARNING: Do not attempt to modify this tool
or create accessories not recommended for use
with this toot. Any such alteration or modification is
misuse and could result in a hazardous condition
leading to possible serious personal injury.
_ WARNING: To prevent accidental starting that
could cause serious personal injury, always remove
the battery pack from the tool when assembling
parts.
REMOVING BATTERY PACK
See Figure 2.
NOTE: The saw is assembled with the battery pack
attached.
[] Locate latches on side of battery pack and depress to
release battery pack from the saw.
[] Remove battery pack from the saw.
TO
REMOVE
F DEPRE88LATCHES TO
RELEASE BATTERYPACK
LATCHES
BATTERYPACK
10
Fig. 2